Step 7 Leveling The Dishwasher - Samsung DMT800 Series Installation Manual

STEp 7 levelING The dIShWASher

1. Open the door and place the level against the top of the
tub from inside and check whether the dishwasher is level.
If it is not level, rotate the leveling legs at the bottom front
of the dishwasher until the dishwasher is level.
2. Check whether the dishwasher is upright (perpendicular),
as shown in the figure to the right.
3. Open the door of the dishwasher and
check whether both the tub and door
clearances are correct.
If not, rotate the leveling legs at the bottom
front of the dishwasher.
If the leveling legs are rotated to the left (counter
clockwise), they are loosened and the front of the
dishwasher is raised. If they are rotated to the right
(clockwise), they are tightened and the front of the
dishwasher is lowered.
To adjust the height of a rear leg, turn the Hexbolt (at
the front of the base) to the left to raise the back of
the dishwasher using the proper tool(Hex L-wrench or
similar tool).
When pull out or lay down the dishwasher for installing,
make sure to adjust bottom leg's height. It should be tightened to block the leg's breakage.
CAUTION
installation_DD68-00046A-03_EN.indd 13
installing the dishwasher _13
2010-10-19 2:25:00