JVC RX-6010VBK Service Manual page 7

Removing the system control board /
power switch board
Prior to performing the following procedure, remove
the top cover and the front panel assembly.
1. Pull out the volume knob on the front side of the front
panel and remove the nut attaching the system
control board.
2. Remove the two screws P
switch board.
3. Disconnect the harness from connector CN714 on
the power switch board.
4. Remove the six screws Q
control board on the back of the front panel.
5. On the back of the front panel, release the eight
joints by pushing the joint tabs inward.
Remove the operation switch panel toward the front.
6. Release the two hook attaching the system control
board.
(See Fig.16 to 18)
attaching the power
attaching the system
RX-6010VBK/ RX-6012VSL
Operation switch panel
Nut
Fig.16
Q
Q
Joint
Joint
Joint
Joint Joint Joint
Fig.17
System control board
Hook
Hook
Fig.18
Front panel assembly
Volume knob
Power switch
board
Joint
P
Joint
CN714
1-7