JVC RX-6010VBK Service Manual page 6

RX-6010VBK/ RX-6012VSL
Removing the power transformer
Prior to performing the following procedures, remove
the top cover.
1. Cut off the tie band fixing the harness.
2. Unsolder the two harnesses connected to the power
transformer.
3. Disconnect the harness from connector CN251 and
unsolder the harnesses connected to FW201 on the
power transformer board.
4. Remove the four screws M
transformer.
Removing the voltage selector board and
the power / fuse board
Prior to performing the following procedure, remove
the top cover and the rear panel.
1. Unsolder the six harnesses connected to the power
transformer board and remove the voltage board.
2. Remove the screw N
board.
3. Unsolder the power cord and other harnesses
connected to the power / fuse board.
Removing the power supply board
Prior to performing the following procedure, remove
the top cover and the front panel.
1. Remove the one nut attaching the headphone jack of
the power supply board on the front side of the body.
2. Disconnect the harness connected to connector
CN241,CN201,CN203 and CN291 on the power
transformer board.
Remove the three screws O attaching the power
3. supply board and pull out the power supply board
from the front bracket backward.
Unsolder the three harnesses connected to the
4. power supply board.
1-6
(See Fig.13)
attaching the power
(See Fig.13)
attaching the power / fuse
(See Fig.14 and 15)
FW201
CN251
M
M
Solder
(from the
power/ fuse
Voltage selector
board)
Power cord
Fig.13
Power
supply
board
Fig.14
CN201
Power
supply board
O
CN241
CN203
CN291
Hook
Fig.15
Power
supply
board
Solder
Tie band
Power
transformer
board
Power
transformer
Power
transformer board
Solder (from the
voltage selector
board)
Tie band
N
Solder
board
Power / fuse board
Headphone jack
Nut
Headphone jack
O
Solder
O
Solder