Table of Contents
Advertisement
NOTES:
● Charging times are for a fully discharged battery
pack.
● When the battery/CF card cover is opened or the
SD card is removed while the power is on, the
power is automatically turned off to protect the
data in the recording medium. To turn on the
power again after opening the battery/CF card
cover, close the cover. To turn on the power again
after removing the SD card, close the cover and
set the power switch to OFF, then to
● It is recommended that only genuine JVC
batteries are used in this camera. Using generic
non-JVC batteries can cause damage to the
internal charging circuitry.
● If the protective cap is attached to the battery
pack, remove it first.
● When charging the battery pack for the first time
or after a long storage period, the power/charge
lamp may not light. In this case, remove the
battery pack from the camera, then try charging
again.
● If the battery operation time remains extremely
short even after having been fully charged, the
battery is worn out and needs to be replaced.
Please purchase a new one.
● Using the optional AA-V200 battery charger, you
can charge the BN-VM200U battery pack without
the camera.
● Since the AC adapter processes electricity
internally, it becomes warm during use. Be sure to
use it only in well-ventilated areas.
Using the Battery Pack
Perform steps 2 – 4 in "Charging the Battery
Pack".
Maximum continuous recording time
Battery pack
BN-VM200U (provided)
NOTES:
● Recording time is reduced significantly under the
following conditions:
• Zoom or record-standby mode is engaged
repeatedly.
• Playback mode is engaged repeatedly.
● Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned recording time.
or
.
Recording time
1 hr.
GETTING STARTED
Using AC Power
Connect the AC adapter to the camera.
Open the cover.
To DC
connector
AC Adapter (ex. AP-V17E)
NOTE:
The provided AC adapter features automatic voltage
selection in the AC range from 110 V to 240 V.
ATTENTION:
● Before detaching the power source, make sure
that the camera's power is turned off. Failure to do
so can result in a camera malfunction.
● If the camera is a subject to electrostatic
discharge, turn the power off before using it again.
About Batteries
DANGER! Do not attempt to take the batteries
apart, or expose them to flame or excessive
heat, as it may cause a fire or explosion.
WARNING! Do not allow the battery or its
terminals to come in contact with metals, as this
can result in a short circuit and possibly start a
fire.
The Benefits of Lithium-Ion Batteries
Lithium-ion battery packs are small but have a
large power capacity. However, when one is
exposed to cold temperatures (below 10°C), its
usage time becomes shorter and it may cease to
function. If this happens, place the battery pack
in your pocket or other warm, protected place for
a short time, then re-attach it to the camera.
15
EN
mark
To AC outlet
Advertisement
Table of Contents
