Electrical Service And Repair - Heat & Glo BE-41C Owner's Manual

PLUG-IN
3V TRANSFORMER
ON/OFF
WALL SWITCH
IGNITION
MODULE
(3V)
VALVE
GROUND
NEUTRAL
BLACK WIRE CAN BE
PLUGGED INTO ANY
OF #1 - #5 LOCATIONS
ON THE HOT SIDE
WHITE WIRE CAN BE
PLUGGED INTO ANY
OF#1 - #5 LOCATIONS
ON THE NEUTRAL SIDE
TRANSFORMER
3 VAC
PLUG-IN
Figure 12.2 IntelliFire Pilot Ignition (IPI) Wiring Diagram
E. Electrical Service and Repair
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
STANDING
PILOT
WHT
RED
Figure 12.3 Standing Pilot Ignition Wiring Diagram
IGNITION MODULE 3 VAC
LOW VOLTAGE
SEE NOTE 1
REMOTE
CONTROL HOT
BLK
RED
BRN
RED
VALVE
ON/OFF PIGGYBACK WIRE
Heat & Glo • BE-41C / LP, BE-41IPIC / LP • 2105-900 Rev. P • 6/09
INTERMITTENT
PILOT IGNITOR
ORG
WHT
GROUND TO
FIREPLACE
CHASSIS*
ORG
VALVE
REMOTE
JUMPER WIRE
WARNING! Risk of Shock! Replace damaged wire with
type 105º C rated wire. Wire must have high temperature
insulation.
Note: Appliance will not operate
unless properly grounded.
THERMOSTAT
WIRE
ASSEMBLY
THERMOSTAT
WIRE ASSEMBLY
49