Table of Contents
Advertisement
Adjusting Signal Settings
Although the projector normally detects and optimizes the input
signal automatically, you can use the Signal menu to make manual
adjustments. In addition to changing the position of the projected
image, you can correct tracking and sync for computer images, or
change the aspect ratio.
1. Press the
button and select the
Menu
screen similar to one of those below. (The settings will be different
depending on the source you are projecting from.)
Computer/RGB video
Composite video/S-Video
2. Adjust the desired options as needed:
■
Auto Setup
Leave this setting
images. Turn it off if you want to save adjustments you have
made to the Tracking, Sync, and Position settings.
■
Resolution
Set to
to have the projector automatically identify the
Auto
resolution of the input signal. If necessary, select
widescreen images) or
Signal
Component video
HDMI (EX51/PowerLite W8+ only)
to automatically optimize computer
On
(for 4:3 ratio images).
Normal
menu. You see a
(for
Wide
Fine-Tuning the Projector
65
Advertisement
Table of Contents
