Planar SL3250 User Manual page 4

Simplicity Series
Regulatory Information:
Products: SL3250, SL4250, SL4650 and
SL5550; Regulatory Models: DS323QBT,
DS423QBT, DS463QBT and DS553QBT.
CE Declaration of Conformity
We declare under our responsibility that the product is in
conformity with the following standards:
• EN60065:2002+A1:2006+A11:2008+A2:2010+A12:2011
(Safety requirement of Audio, video and similar electronic
apparatus)
• EN55022:2010 (Radio Disturbance requirement of
Information Technology Equipment)
• EN55024:2010 (Immunity requirement of Information
Technology Equipment)
• EN61000-3-2:2006 +A1:2009+A2:2009 (Limits for Harmonic
Current Emission)
• EN61000-3-3:2008 (Limitation of Voltage Fluctuation and
Flicker)
• EN 50581:2012 (Technical documentation for the
assessment of electrical and electronic products with respect
to the restriction of hazardous substances)
following provisions of directives applicable:
• 2006/95/EC (Low Voltage Directive)
• 2004/108/EC (EMC Directive)
• 2009/125/EC (ErP Directive, EC No. 1275/2008, 642/2009
Implementing Directive for Standby and Off mode power
consumption)
• 93/68/EEC (Amendment of EMC and Low Voltage Directive)
and is produced by a manufacturing organization on
ISO9000 level.
• 2011/65/EU (RoHS 2 Directive)
iv
Federal Communications Commission (FCC)
Notice (U.S. Only)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when
the equipment is operated in a commercial
environment. This equipment generates, uses
and can radiate radio frequency energy and,
if not installed and used in accordance with
the instructions manual, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely
to cause harmful interference in which case the
user will be required to correct the interference
at his own expense.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
Use only an RF shielded cable that was supplied with the
display when connecting this display to a computer device.
To prevent damage which may result in fire or shock hazard, do
not expose this appliance to rain or excessive moisture.
THIS CLASS B DIGITAL APPARATUS MEETS ALL
REQUIREMENTS OF THE CANADIAN INTERFERENCE-
CAUSING EQUIPMENT REGULATIONS.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.