Nikkai A31JL Owner's Manual page 7

■ Connecting Receiver to Remote TV through VCR
This setup enables you to record transmitted audio and video on your remote
VCR and also enjoy the picture and sound on a remote TV at the same time.
1. Connect VCR and receiver with RCA lead, just plug RCA plugs to the
RCA input of VCR. If your VCR has only SCART socket for audio/video
input, you can use a SCART/RCA adapter (not included) to connect the RCA
plug of the transmitter and the SCART socket of TV. Then connect TV and
SCART output of VCR using a "SCART to SCART A/V CABLE" (with must
be purchased additionally). Please follow the instruction figure below.
2. If your TV has A/V input jacks, connect another set of A/V cables to the
TV's A/V input jacks and to the A/V output jacks on your VCR.
3. If your TV does not have any A/V input jacks, please connect a 75 ohm
coaxial cable (not included) from the TV's antenna in (or RF in) to VCR's
modulator output.
This feature is optional
4. Plug one end of the sender power adapter into the back of the receiver and
the other end into any 230-volt (or 120 volt) wall outlet, DC in jack
7.5V/500mA. Use only the adapter provided.
5. Locate and orient the receiver to best video and sound quality please
according to the section of this manual titled "Orienting Units for optimum
Performance".
11
RECEIVER
Power
adapter
3.5mm stereo plug(4 pole)
to 3RCA plug
TV ANT IN
IN
75 OHM Coaxial Cable
OUT
TV (must be purchased)
A/V IN
RF IN Recommended TV connection for
dual-output VCR's SCART CONNECTOR A/V CABLE
Fig. 4a
RECEIVER
Power
adapter
3.5mm stereo plug(4 pole)
to 3RCA plug
TV ANT IN
IN
75 OHM Coaxial Cable
OUT
TV (must be purchased)
A/V IN
RF IN
Recommended TV connection for
dual-output VCR's SCART CONNECTOR A/V CABLE
Fig. 4b
12
YELLOW RED WHITE
SCART/RCA Adapter
(Not Included)
VCR
LINE
IN
LINE
OUT1
LINE
OUT2
VCR
LINE
IN
LINE
OUT1
LINE
OUT2