Nikkai A31JL Owner's Manual

Nikkai A31JL Owner's Manual

5.8ghz wireless a/v sender

Advertisement

Quick Links

Maplin Electronics,
National Distribution Centre,
Valley Road (off Station Lane),
Wombwell, Barnsley,
South Yorkshire, S63 5DL
Model A31JL
5.8GHz WIRELESS A/V SENDER
OWNER'S MANUAL
(PLEASE READ BEFORE USE)
PLEASE CONSULT THE BACK COVER OF THIS
OWNER'S MANUAL FOR MODEL AND FEATURE

Advertisement

Table of Contents
loading

Summary of Contents for Nikkai A31JL

  • Page 1 Model A31JL 5.8GHz WIRELESS A/V SENDER OWNER’S MANUAL (PLEASE READ BEFORE USE) Maplin Electronics, National Distribution Centre, Valley Road (off Station Lane), Wombwell, Barnsley, South Yorkshire, S63 5DL PLEASE CONSULT THE BACK COVER OF THIS OWNER’S MANUAL FOR MODEL AND FEATURE...
  • Page 2: Important Safety Precautions

    ■ A. Checking Contents of Box Important-Safety Precautions This device of which operation is subject to the following two conditions Checks and make sure that all of the items shown as below are included with (1) This device may not cause harmful interference. your 5.8 GHz Wireless A/V Sender System.
  • Page 3: Product Layout

    ■ The Using Attention B. Introduction to 5.8GHz Wireless A/V Link The outlet of the power supply must have the same voltage as the This sender system is a wireless audio/video sender that uses local area. advanced wireless communication technology to deliver consistently 1.
  • Page 4: Video Sources

    REAR VIEW FOR TRANSMITTER D. Setting Up 5.8GHz wireless A/V Link To enjoy wireless video and audio, just connect the transmitter to whatever audio/video source you want to enjoy from another location, and connect the receiver to the TV, monitor or powered speakers in 5.8G Ant that other location.
  • Page 5 ■ How To Transmit Audio/Video from Your VCR TRANSMITTER Connect VCR and transmitter with 3.5mm stereo plug (4 pole) to 3RCA plug AV cable, just plug RCA plugs to RCA sockets of VCR and plugs 3.5 stereo plug to A/V in port of transmitter. If your VCR has only SCART 3.5mm stereo plug (4 pole) to scart plug cable socket for audio/video output, you can use a SCART/RCA adapter (not...
  • Page 6 ■ How To Receive Wireless Audio/Video Signals on Your TV TRANSMITTER There are two ways to receiver wireless audio/video signals on your remote TV (TV in another location such as in bedroom, kitchen). · Connect the receiver directly to the remote TV. 3.5mm stereo plug (4 pole) YELLOW WHITE...
  • Page 7 ■ Connecting Receiver to Remote TV through VCR RECEIVER This setup enables you to record transmitted audio and video on your remote VCR and also enjoy the picture and sound on a remote TV at the same time. YELLOW WHITE Power adapter 1.
  • Page 8 E. Orienting Units for Optimum Performance ANTENNA ANTENNA RAISED RAISED This sender system should be placed on a flat, stable surface to prevent SIDE SIDE damage to it from falling. ANTENNA RAISED For optimum performance, both the audio/video and remote control antennas SIDE should be carefully oriented as described below.
  • Page 9: Troubleshooting, Care And Maintenance

    Sometimes, it may be difficult or even impossible to orient the transmitter unit G. Troubleshooting, Care and maintenance such that it can be "seen" (means face-to-face) by theA/V equipment you wish Please read this owner's manual carefully and follow the steps described in it. If to control.
  • Page 10: Specifications

    All electrical and electronic equipment H. Specifications Transmitter: WEEE Directive & Product Disposal Operating Frequency Band 5.725GHz~5.875GHz At the end of its serviceable life, this product Transmit power output 25 mW(CE) should not be treated as household or general Modulation (video and audio) waste.

Table of Contents