Page 1
® ™ SCS175 ( 230V ) PRELIMINARY Service - Technical Manual Harman International SNC - Harman Consumer International 2, route de Tours 72500 Château du Loir FRANCE...
one. Speaker Placement Subwoofer Satellites Always start with the subwoofer as close to one of the front cor- ners as possible to take advan- tage of solid-angle gains. If you get too much bass, adjust the ”VOLUME” towards ”MIN”. The result will be lower distortion and higher reliability.
two. Speaker Connections Connection Tips Separate and strip the ends of tant to connect all the speakers the speaker wire as shown. identically: (+) on the speaker Speakers and amplifiers/- to (+) on the amplifier and (–) receivers have corresponding on the speaker to (–) on the (+) and (–) terminals.
Line Level If your receiver has subwoofer output jacks, you may connect the SCS175 using this method. SCS175 (230V) simple setup guide Serie no. Made in Denmark Harman Consumer International Note: Some receivers/ amplifiers have a single (mono) subwoofer output. In this case, it is recommended Center that you use a “Y”-connector...
Troubleshooting If there is no sound from any If there is no sound coming If there is low bass output, of the speakers, check the from one speaker, check the check the following: following: following: • Make sure the connections to •...
Page 8
ATTENTION! OUTPUT TRANSISTOR CHANGE Old Version: In amplifiers with serial number lower then SUB01091226, the output transistor was called D718/B688 New Version: In amplifiers with higher serial numbers then SUB01091226 new output transistor is used D1047/B817. In case a (TLX) SCS175 SUB amplifier is for repair, replace the output transistor to the new type.
Need help?
Do you have a question about the Simply Cinema SCS175 and is the answer not in the manual?
Questions and answers