Toshiba TRCS02 User Manual page 25

Steam escaping
from the rice
cooker
Rice cooker
boiling over and
spattering
NOTE: It is normal
for moisture to
appear on the inner
lid or cooking pot
and drip when the
lid is opened.
Difficult to close
the cooker lid
Film on interior of
cooking pot
ERROR DISPLAY
PROBLEM POSSIBLE CAUSE
E1, E2, E5,
Circuit Board and
E6, EU
Sensor Fault
The inner lid is not attached
properly.
The inner lid and/or cooking pot
is deformed.
Foreign substances are stuck to
the inner lid, cooking pot rim or
the frame of the rice cooker.
The inner lid and/or steam vent
are not attached properly.
The steam vent and/or
temperature sensor is dirty.
Porridge program was
unintentionally used to cook rice.
The inner lid is not attached
properly.
NOTE: The outer lid will not
close unless the inner lid is
attached correctly.
Foreign substances in the lid
latch well are preventing the
outer lid from latching.
The starch in the rice will melt
during cooking and dry onto the
interior of the cooking pot.
SOLUTION
Immediately unplug rice cooker.
After error is resolved, plug in rice cooker, and then
press CANCEL to remove error code from display.
Page 23
Check the condition of the inner
lid and gasket. Confirm that the
inner lid is correctly seated in
the cooker cover.
Clean both the cooking pot and
rice cooker after each use.
After cleaning replace both the
inner lid and steam vent into
the rice cooker. See "Care and
Cleaning. "
Clean the steam vent and
temperature sensor.
Select the cooking program for
the ingredients you are cooking.
Replace the inner lid into the
top cover of the rice cooker. See
"Care and Cleaning. "
Remove debris from the lid
latch well.
During washing, use a non-
abrasive plastic scouring pad
or utensil to gently remove the
film.