Download Print this page

Khyam AIRTEK KAMPER PRO 1 Pitching & Striking Instructions

Advertisement

Quick Links

Pitching & Striking Instructions for :-
AIRTEK KAMPER PRO 1
Visit our YouTube Channel for an instructional video of this model
PLEASE ENSURE YOU READ THE INSTRUCTIONS THOROUGHLY
PRIOR TO ASSEMBLING YOUR NEW PURCHASE
(ANY DAMAGE THAT OCCURS AS RESULT OF FAILURE TO READ INSTRUCTIONS IS NOT COVERED BY THE WARRANTY)

Advertisement

loading
Need help?

Need help?

Do you have a question about the AIRTEK KAMPER PRO 1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Khyam AIRTEK KAMPER PRO 1

  • Page 1 Pitching & Striking Instructions for :- AIRTEK KAMPER PRO 1 Visit our YouTube Channel for an instructional video of this model PLEASE ENSURE YOU READ THE INSTRUCTIONS THOROUGHLY PRIOR TO ASSEMBLING YOUR NEW PURCHASE (ANY DAMAGE THAT OCCURS AS RESULT OF FAILURE TO READ INSTRUCTIONS IS NOT COVERED BY THE WARRANTY)
  • Page 2: Component Checklist

    Component Checklist Prior to assembling your new purchase please carefully check the contents to make sure you are not missing any parts. Airtek Kamper Pro 1 Carry Bag Awning Pump & hose assembly (rolled up in centre) Fibreglass Side Canopy Pole...
  • Page 3 Pitching your tent/awning Unroll the awning and peg the four corners - we recommend the use of a SPS Footprint to keep the bottom of the awning clean. - Pegging points may need adjusting/tightening once the awning is erected. Prior to inflating the awning, unzip a couple of doorways, this allows air to enter the inside whilst inflating and prevents the unit acting like a vacuum, making the erection process easier.
  • Page 4 Pitching your tent/awning Once all tubes are inflated lift the awning and push the tubes until the awning pops up and sits correctly Zip any open doorways shut, Connect onto Adjust the corner pegs if needed and tighten Campervan using your chosen method, then peg webbing straps, then peg all remaining pegging out front storm straps.
  • Page 5 Pitching your tent/awning When disconnecting and driving off for the day, roll the connection tunnel out of the way and tie back. Zip driveaway door closed, remember to tuck/toggle groundsheet up inside Ensure you peg out guy lines and storm straps to give awning full support when leaving unattended. Secure dust cap over each valve and Velcro down waterproof cover.
  • Page 6 Packing your tent/awning Unpeg all pegging points and tie guy ropes up to prevent tangling - Leave just the corners and Storm Straps pegged. Remove the fibreglass side pole and interior adjustable pole. To deflate the tent/awning unscrew the dust cap on the valve and depress the spring button on the valve, repeat this on all the air tubes and the awning will then drop to the floor - leave a couple of doorways open slightly and this will allow air to escape from inside quickly.
  • Page 7 Packing your tent/awning Start rolling the awning up towards the side with the Speed Valves - This will push any remaining air in the tubes out as you roll. Squeeze as much air out as you can while you roll. Secure the rolled awning with a tie, place the bag on upside down and the roll over in the carry bag (saves having to lift awning into carry bag) Zip Carry bag up and secure webbing straps on bag.
  • Page 8 Q. How long are products covered for? We go that bit further at Khyam. We don’t just guarantee our products for a set time frame. We like to be more flexible because the lifespan of our products varies depending on a few factors. For example, a heavily used or poorly maintained item will probably have a shorter life than an averagely used or well-looked after item.
  • Page 9 Q . Are Khyam awnings water resistant? All Khyam flysheet fabrics are coated to withstand in excess of 5000mm head of water in the hydrostatic head test. This is a measure by which we can test the resistance of water penetration. This is the measurement when the fabric is new and in use over a period of time this level will drop.
  • Page 10 OTHER USEFUL POINTS TO BEAR IN MIND. 1. Never remove pegs by pulling up on the poles or fabric by doing this you may damage the pole or awning invalidating the guarantee. Always use a peg puller or another peg 2.