Advertisement
Pitching & Striking Instructions for :-
WARNING:
If this tent / awning is not erected in accordance with the instructions damage could be caused to the
joints, poles or fabric. It is important that the tent is properly guyed at all times, particularly in strong winds
otherwise pole or joint damage may occur.
DO NOT PUSH TENT PEGS IN BY HAND, ALL TENT PEGS SHOULD BE DRIVEN HOME USING A
WOODEN OR RUBBER FACED MALLET OR SIMILAR TOOL.
Advertisement
Table of Contents
Related Manuals for Khyam Hub
Summary of Contents for Khyam Hub
- Page 1 Pitching & Striking Instructions for :- WARNING: If this tent / awning is not erected in accordance with the instructions damage could be caused to the joints, poles or fabric. It is important that the tent is properly guyed at all times, particularly in strong winds otherwise pole or joint damage may occur.
- Page 2 Page 1 Pitching your Annexe Unpeg all pegging points and guy ropes on the panel you wish to remove. Neatly tie the guy ropes up in a loose knot ready for use next time, see fig 1. Unclip the zip retainer and then unzip the panel, see fig 2 & 3 Disconnect the two halves of the zip, remove the panel and fold neatly ready for storage, see fig 4-6 Remove the bedroom annexe from its carry bag and unfold along side your awning, see fig 7-8.
- Page 3 Page 2 Pitching your Annexe Set the telescopic pole on the base of the poles with curved upper sections, to the lowest setting, see fig 16. Thread the 3 section straight roof pole, through the roof sleeves, see fig 17 – 18. Starting on the side of the awning facing away from your vehicle, take one of the poles with the curved upper section and locate the upper curved end over the end of the straight roof pole.
- Page 4 Page 3 Pitching your Annexe Locate and secure the bedroom annexe side panel guy rope to the ring on the main corner guy rope of the awning. See fig 31 - 32 If you have purchased the Bedroom Annexe ‘Clip In’ groundsheet it can be clipped in now. If not please proceed to Fig 43.
- Page 5 Page 4 Pitching your Annexe When clipping the rear of the inner tent up into position, you may find it easier to open one doorway, step onto the sewn in groundsheet of the inner and then lift the inner tent fabric up to clip into position.
- Page 6 Over many years we have heard many questions and position and using the brush or pad provided with the comments relating to Khyam awnings and we feel it is sealant, apply the sealant to the seam on the outside relevant to list various aspects of this information for of the flysheet.
- Page 7 4. When setting up a Khyam awning always use caution to prevent any fabric being caught in the pole system.
Need help?
Do you have a question about the Hub and is the answer not in the manual?
Questions and answers