Summary of Contents for Extreme Networks Mogul-100
Page 1
Mogul–100 Quick Guide The Mogul-100 connects an Ethernet network to a Very High speed Digital Subscriber Line (VDSL), so it allows your Ethernet local area network (LAN) to connect to a wide area network (WAN). The Mogul–100 is compatible with the Extreme Networks VDSL module for the Alpine 3800 series switch.
Page 2
Connecting the Mogul-100 Connect the power supply to your local AC power. Connect the power supply to the back of the Mogul-100. The green POWER LED will light up. Connect the RJ11 cable specified by your service provider to the WAN port on the Mogul-100.
Page 3
The Mogul-100 can be attached to a wall. Use two screws, installed 90 mm apart. Use a 6-32 round head screw (maximum shaft diameter 3.5 mm, maximum head diameter 7 mm). If attaching to drywall, use drywall anchors or install the screws into a wall stud.
Page 4
Power Supply AC Line Frequency Input Voltage Options Current Rating -10° to 70 ° C 10% to 95% relative humidity, noncondensing EN60068 to Extreme IEC68 schedule UL 1950 3rd Edition, listed EN60950:1992/A1-4:1997 plus ZB/ZC Deviations IEC 950CB Low Voltage Directive (LVD) CSA 22.2#950-95...