Important Safety Instructions - Russell Hobbs Steam & Clean RHSM1001-G Operating Manual

IMPORTANT SAFETY INSTRUCTIONS

• It is hazardous for anyone other than a competent person to carry out any service
or repair operation that involves the removal of a cover which gives protection
against exposure to electrical parts.
• Do not remove parts from the appliance such as screws.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard. Do not use with
damaged cord or plug.
• This product is intended for household use only. Do not use outdoors.
• This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children should
not play with the appliance. Cleaning and user maintenance should not be made
by children without supervision.
• Do not direct at people, animals, electrical outlets, or equipment containing
electrical components.
• The use of accessory attachments, detergents or cleaning solutions not
recommended by the appliance manufacturer may cause fire, electric shock,
injury or damage. Use only those as recommended by the manufacturer.
• Descale the product monthly using 50% white vinegar & 50% water solution.
• Do not use in enclosed spaces filled with vapour, such as paint thinner, moth
proofing substances, or any flammable or combustible vapours.
• Do not use on leather, wax polished floors, natural wood and/or unsealed floors,
and any fabric not recommended for steam treating. If in doubt, consult the
flooring manufacturer and test an inconspicuous area.
• Do not store with a wet pad attached.
• Do not immerse in water, such as for cleaning.
• Clean pads at least monthly. Change filter when required.
• Distilled or demineralized water will maximise the performance of the mop.
Quality testing during manufacture may result in water droplets remaining in the
•
tank. This is normal.
• If you shake this product the water cut-off valve will make a rattling noise. This is
normal and is not a defect.
Symbol IEC 60417-5597 (2002-10) is used on the unit to
indicate that this unit operates with hot water vapour (steam).
To avoid scalding and burns take extra care when in use
RHSM1001-G Revision 4.1