Campania International FT-265 Assembly Instructions

Fountain Components
Image Item Description
Fountain Disc
Fountain Basin
Assembly & Installation - A fountain can be diffi cult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Fountain Information:
• This fountain holds approximately 1 gallon of water.
• A fountain cover is not available for this fountain.
• No refi ll device or submersible lights are suggested for this fountain.
Pump Information:
WP450LV - 120 GPH Low Voltage Pump (16 ft. cord length)
Tools Required:
Bubble Level
Screwdriver
Scissors
Component
Quantity
Item #
M-Series
Camellia FT-265A
M-Series
Camellia FT-265B
Fountain Set-Up:
FT-265 M-Series Camellia Fountain
Image
1
1
Assembly Instructions
Pump Kit Parts List
Component
PK120-LV Pump with Transformer
#10 Stopper
2-1/2" length of PermaGum Putty
Approx. 12" length of 1/2" black
non-kink tubing
Approx. 1" length of 5/8" clear tubing
Approx. 1" length of 1/2" CPVC Pipe
Adhesive Dots
Hose Clamp
Proudly
MADE IN USA
Quantity
1
1
1
1
1
1
4
1
rev 3/30/2020