Advertisement
Tip!
Keep the spray gun perpendicular to the
surface. Otherwise one end of the pat-
tern will be thicker than the other.
Tip!
Trigger gun after starting the stroke. Release the trigger before ending the stroke. The spray gun
should be moving when the trigger is pulled and released. Overlap each stroke by about 30%.
This will ensure an even coating.
If you expect to be away from
your sprayer for more than one
hour, follow the 18. Short-Term
Storage instructions.
10. Spraying Troubleshooting - Unclogging the Spray Tip
If the spray pattern becomes distorted or stops completely while the gun is triggered, fol-
low these steps.
Do not attempt to unclog or clean the tip with your finger.
Note!
Do not use a needle or other sharp pointed instrument to clean the tip. The hard tung-
sten carbide can chip.
1. Release the trigger and lock the gun off. Rotate the reversible tip arrow 180º so that the point of
the arrow is toward the rear of the gun (CLEAN position).
Under pressure, the spray tip may be very difficult to
turn. Turn the PRIME/SPRAY knob to PRIME and trig-
ger the gun. This will relieve pressure and the tip will
turn more easily.
https://www.XPOtool.com
The Tool Experts
Gun locked
Artikel 63003
Seite 13
04
2021-1
Advertisement
