SBS Dj Touch Manual page 4

UK
INSTRUCTION MANUAL
Charging the Headphones
Plug one end of the included charging cable into the Micro USB port
on the headphones. Plug the other end into a charging point with
a USB port.
The LED will turn red while recharging (approximately 2 hours for
full recharge). When the LED turns blue, the headphones will be
fully recharged.
Turning the headphones on:
Press the MLF button on the headphones for approximately 3
seconds. You'll hear a BEEP and the LED will flash red and blue. The
headphones are now on.
Turning the headphones off:
Press the MLF button on the headphones for about 4 seconds. You'll
hear a BEEP and the LED will go off. The headphones are then off.
Connecting the headphones to a single device
Turn the headphones on. Shortly after, the LED will flash red and
blue. Open the Bluetooth settings on the device you want to connect
with. Search for "SBS DJ TOUCH" (the headphones) in Bluetooth
and select it.
Connecting to 2 devices
Connect the headphones to the first device as indicated above.
Then, turn that device off.
Next, connect the headphones to the second device in the same
way. Then, turn the first device on again and the headset will
automatically be connected to both devices.
Controls
Press the MLF button once (1) to answer/hang up a call.
Press the MLF button once (1) to play/pause music.
press the up arrow to turn the volume up
press and hold the up arrow to return to the previous song
press the down arrow to turn the volume down
press and hold the down arrow to skip to the next song
4