Rangemaster RMB70HPNGFGL User Manual page 13

Check the appliance is electrically safe and gas sound when you have finished.
Provision of Ventilation
This appliance is not connected to a combustion products
evacuation device. Particular attention shall be given to the
relevant requirements regarding ventilation.
In the UK
The room containing the hob should have an air supply
in accordance with BS 5440 Part 2. All rooms require an
openable window or equivalent, while some rooms require a
permanent vent in addition to the openable window. The hob
should not be installed in a bedsitting room with volume less
than 20m³. If it is installed in a room of volume less than 5m³
an air vent of effective area 100cm² is required; if it is installed
in a room of volume between 5m³ and 10m³, an air vent of
effective area 50cm² is required; while if the volume exceeds
11m³, no air vent is required.
If there are other fuel burning appliances in the same room,
BS 5440 Part 2 should be consulted to determine the requisite
air vent requirements.
In the Republic of Ireland
Reference should be made to the current edition of IS 813,
which makes clear the conditions that must be met to
demonstrate that sufficient ventilation is available.
INSTALLATION
Location of the Hob
The hob may be installed in a kitchen/kitchen diner but NOT
in a room containing a bath or shower.
NOTE: An appliance for use on LPG shall not be installed
in a room or internal space below ground level, e.g. in a
basement.
Conversion
All models are supplied set for use on group H natural gas.
A conversion kit for LP gas is included with the appliance.
See the instructions that are supplied with the conversion
kit. After converting the appliance please attach the Gas
Conversion sticker over the appropriate area of the data
badge; this will identify the gas type the appliance is now set
for.
This appliance is designed for domestic cooking only. Use for
any other purpose could invalidate any warranty or liability
claim.
You will need the following equipment to complete the hob
installation satisfactorily:
• Gas Pressure tester
• Flexible gas hose
• Multimeter
You will also need the following tools:
• Electric drill
• Jigsaw
• Steel tape measure
• Cross head screwdriver
• Pencil
• Adjustable spanner
• Sharp knife
Checking the Parts
Check that the appliance is in a good condition after having
removed the packaging. In case of doubt, do not use the
appliance and contact the retailer.
Never leave the packaging materials (cardboard,
n n
plastic bags, polystyrene foam, etc.) within children's
reach since they could become potential sources of
danger.
9