Summary of Contents for Impex MARCY DIAMOND ELITE MD-440
Page 1
Safety Notice Hardware Identifier MD-440 Assembly Instruction Parts List Warranty Ordering Parts Model MD-440 Retain This Manual for Reference 07-23-05 OWNER'S IMPEX INC. MANUAL 14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746 Tel: (800) 999-8899 Fax: (626) 961-9966 www.impex-fitness.com info@impex-fitness.com...
BEFORE YOU BEGIN Thank you for selecting the MARCY DIAMOND ELITE Utility Bench MD-440 by IMPEX INC. For your safety and benefit, read this manual carefully before using the machine. As a manufacturer, we are committed to provide you complete customer satisfaction. If you have any questions, or find there are missing or damaged parts, we guarantee you complete satisfaction through direct assistance from our factory.
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC. ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
Page 4
WARNING LABEL REPLACEMENT The Warning Label shown here has been placed on the Front Stabilizer. If the label is missing or illegible, please call customer service at 1-800-999-8899 for replacement. Apply the label in location shown.
ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches. NOTE: It is strongly recommended this machine be assembled by two or more people to avoid possible injury. STEP 1 (See Diagram 1) A.) Attach the Main Frame (#1) onto the Front & Rear Stabilizers (#2 & 6). Secure each end with two M10 x ¾”...
Page 8
STEP 2 (See Diagram 2) A.) Attach the Backrest Supports (#3) to the pivot on the Main Frame (#1). Secure it with one M12 x 5 ¾” Allen Bolt (#31), two Ø1” Washers (#38), and one M12 Aircraft Nut (#36). Do not over tighten the Nut and Bolt, make sure the Backrest Supports are able to swivel.
Page 9
STEP 3 (See Diagram 3) A.) Attach the Leg Developer (#5) to the open bracket on the Main Frame (#1). Secure it with one Axle (#42), two M10 x 5/8” Allen Bolts (#30), and two Ø ¾” Washers (#39). Do not over tighten the Bolts, make sure the Leg Developer is able to swivel.
Page 10
STEP 4 (See Diagram 4) A.) Attach the Arm Curl Pad (#13) to the Arm Curl Stand (#7). Secure it with two M8 x ¾” Allen Bolts (#33) and Ø 5/8” Washers (#40). B.) Insert the Arm Curl Stand into the front opening on the Main Frame. Use a Lock Knob (#16) to secure the Stand at desired height.
PARTS LIST KEY NO. DESCRIPTION Q’ty Main Frame Front Stabilizer Backrest Support Backrest Incline Support Leg Developer Rear Stabilizer Arm Curl Stand Curl Bar Foam Tube U-shaped Pin Seat Backrest Board Arm Curl Pad Olympic Sleeve Spring Clip Lock Knob 2 3/8”...
IMPEX. IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in connection with the use or performance of the product or other damages with respect to any economic loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation or other consequential damages or whatsoever natures.