Anelto OnTheGo LiTE User Manual

OnTheGo LiTE User Guide

Getting to Know Your OnTheGo LiTE:

#1
#2
#4

Charging Your Device:

Whenever you put the plugged-in charging cable near the charging port on the back of the device, it should latch into
place and the device will automatically power on. The LED will turn solid red and the device will announce, "Your
device is now charging." Note: If you have allowed the battery to completely drain, it may take a few minutes for the
device to power on.
When the device has adequate battery charge and is also connected to the cellular network, it will announce, "Your
device is now ready." This indicates that your device is ready to make an emergency call. However, you should leave
your device on the charging cable until the LED is green, indicating that your device has completed charging.
A complete charge will take approximately 2-3 hours. When fully charged your device should work for up to three
days before needing to be recharged.
LED
Solid Red
Blinking Red
Blinking Green
Solid Green

Placing an Emergency Call:

HELP Button Action
To place a call, press and
hold for 1 second or
more
To cancel a call, press
and hold for 2 seconds
after the "Dialing the
emergency response
center...."
announcement
1)
2)
#3
3)
4)
5)
#5
6)
7)
Announcement
"Your device is now
charging."
"Your device battery is
low. For your protection,
please place your device
on the charger now."
"Your device is now
ready."
Announcement
Device will BEEP and
announce "Placing an
emergency call now. To
cancel the call please press
and hold the HELP button
for two seconds now."
"Your call has been
cancelled."
Lanyard Loop
LED
Speaker
HELP Button (Emergency Button)
Microphone
Charging Cable (Not Shown)
Lanyard (Not Shown)
What this means
Device is connected to the
charger
Your battery is critically
low
Your device has adequate
charge and is looking for
cellular connection
Your device is ready to
make a call
What this means
Device will make a call
The call has been cancelled
What you should do
Leave on charger until
battery is charged and the
LED is green
Place device on charger as
soon as possible
Wait. If this continues
move to another location
with better cell coverage
Press the button if you
wish to make a call
What you should do
Release the button
Release the button