Subscribe to Our Youtube Channel
Related Manuals for Anelto iOnMom Mobile Elite 4G
Summary of Contents for Anelto iOnMom Mobile Elite 4G
- Page 1 Mobile Elite 4G QUICK START GUIDE Personal Emergency Response System Table of Contents Page 1...
-
Page 2: Table Of Contents
Items in your Box ............. 3 Step 1: Reading the Directions ......... 5 Step 2: Preparing your System ......... 6 Step 3: Activating your System ......... 7 Step 4: Talking to the Call Center ........8 Step 5: Wearable Accessories ........... 9 Step 6: Setting up your Wearable ........ -
Page 3: Items In Your Box
Items in your Box Mobile Elite 4G Phone, charging cradle and power cord. 1 Wearable (with Pendant and Wristband Accessories) Page 3... - Page 4 Items in your Box Speaker Network LED Power LED ON/OFF Button EMERGENCY Call Button MESSAGE Button USB on cradle for home use Microphone Charger Pins Power LED Plug into Wall Socket Plug USB into back of Cradle LED Call Indicator (Green or Red) Page 4...
-
Page 5: Step 1: Reading The Directions
Step 1: Reading the Directions 1) Please take a few minutes to read through this quick start guide so you will be familiar with the steps required to set up your System. Mobile Elite 4G 2) Please make sure someone is with you while you are setting up and testing your system. -
Page 6: Step 2: Preparing Your System
Step 2: Preparing your System 1) Locate a place in your home that is central and is near a standard wall outlet. It should be easy to access for daily charging and to allow you to take the Mobile Elite 4G Phone with you when you leave the house. -
Page 7: Step 3: Activating Your System
Step 3: Activating your System 1) Your Phone will prompt you and guide you Mobile Elite 4G through the remaining setup. 2) When your Phone has sufficient charge, it Mobile Elite 4G will say “Hello, it’s time to test your system to make sure it is working properly. -
Page 8: Step 4: Talking To The Call Center
Step 4: Talking to the Call Center 1) The operator should have your name from your original order form, as well as the address where your cradle will be located. The operator will confirm: a. Your name b. Your Cradle address ** The quality of your call d. -
Page 9: Step 5: Wearable Accessories
Step 5: Wearable Accessories 1) The Wearable Button can be exchanged between the Wristband and Pendant. Locate your Wearable Button in the plastic tri-fold box. a. Turn the Wristband or Pendant accessory so the front is resting on a solid surface. You are now looking at the back of the accessory. -
Page 10: Step 6: Setting Up Your Wearable
Step 6: Setting up your Wearable 1) The Wearable is ready to use. Please make sure someone is near your Mobile Elite 4G Phone when testing your Wearable. 2) Press the center of the Wearable (this is where the call button is located) for three seconds. -
Page 11: Step 7: Care4Mom App
Care4Mom app. It may be downloaded from the Apple or Google store. A link to the Apple store may be found at www.anelto.com under the subsection Caregiver Solutions. You may also use this app yourself if you have an Android or iOS smartphone. -
Page 12: Step 8: Receiving Messages
Step 8: Receiving Messages 1) Your loved ones may send you messages using the Care4Mom app. They may wish to remind you of a doctor’s appointment or just wish you a good day. 2) Your Phone may also automatically send Mobile Elite 4G you reminder messages when needed. -
Page 13: Quick Reference: General Information
Quick Reference: General Information 1) When traveling on a plane, press the ON/OFF button on top of the Mobile Elite 4G Phone and hold it down for five seconds to turn it off. Your Mobile Elite 4G Phone will announce, “Your device is powering down now”. -
Page 14: Quick Reference: Led Indicators
Quick Reference: LED Indicators The following is a guide to the LED indicators on the Cradle, Phone, and Wearable: 1) CRADLE GREEN LED – Solid green: Cradle is plugged in and has power. No LED: Cradle has no power. 2) Mobile Elite 4G PHONE GREEN LED (above Signal icon) – Solid Green: Mobile Elite 4G Phone is registered to network and able to make calls. - Page 15 Quick Reference: LED Indicators Page 15...
-
Page 16: Important Tips And Reminders
Remove your wearable and place it where you can easily reach it when performing activities where it may become submerged. 4) Your iOnMom Mobile Elite 4G Phone is not water or splash resistant. 5) Please test your system at least once a month. -
Page 17: Regulatory Compliance: Fcc/Ic
Regulatory Compliance: FCC/IC The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the United States FCC regulations and has an Industry Canada registration (IC ID) of 20951-ANH0319. -
Page 18: Regulatory Compliance: Fcc/Ic (French)
FCC ID: 2AGPI-ANH0319 IC:20951-ANH0319 Model: ANH0319 Contains FCC ID: XMR201606EC21A IC:10224A-201611EC21A Model: Quectel EC21-A Conformité réglementaire : FCC/IC Le manuel ou le manuel d'instructions de l'utilisateur pour un radiateur intentionnel ou non intentionnel doit avertir l'utilisateur que des modifications ou des modifications non expressément approuvées par la partie responsable de la conformité... - Page 19 de corriger l'équipement, l'utilisateur est encouragé à essayer l'interférence par une ou plusieurs des mesures suivantes : Réorienter ou déplacer l'antenne réceptrice. Augmenter la séparation entre l'équipement et le récepteur. Connectez l'équipement à une prise sur un circuit différent de celui auquel le récepteur est connecté.
-
Page 20: Regulatory Compliance: Rf Exposure
Regulatory Compliance: RF Exposure Your device is a radio transmitter and receiver. It is designed and manufactured not to exceed the emissions limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission (FCC) of the U.S. Government and Industry Canada of the Canadian Government. -
Page 21: Regulatory Compliance: Rf Exposure (French)
Conformité réglementaire : Exposition Votre appareil est un émetteur radio et un récepteur. Il est conçu et fabriqué pour ne pas dépasser les limites d'émissions pour l'exposition à l'énergie par radiofréquence (RF) fixées par la Federal Communications Commission (FCC) du gouvernement des États-Unis et D'Industrie Canada du gouvernement canadien. - Page 22 HAVE QUESTIONS? Please refer to the more detailed information at www.anelto.com or contact your Dealer. Page 22...
Need help?
Do you have a question about the iOnMom Mobile Elite 4G and is the answer not in the manual?
Questions and answers