Samsung WF42H5000AW Service Manual page 24

error Type
LeD
Hr
Heater error
(Heater
Relay)
Water Leakage
LE
error
Overflow Error OE
Temperature
tE
Sensor error
22 _ Troubleshooting
For uSA
LCD
- The washing heater is short-circuited or has a wire
disconnected.
- The washing heater in the tub has an error. (Contact
error, temperature sensor fault)
- If the water level sensor operates without water
because water is frozen or for any other reason and
the temperature sensor engaged at the bottom to
prevent overheating for the washing heater detects a
temperature of 100 to 150 ˚C, the washing machine
turns the input power off.
- This error occurs when the red temperature sensor
at the center of the dry heater operates (at a
temperature higher than 145 ˚C)
: Corrective action – Press the button at the center
Alternatively, replace the temperature sensor if the
temperature sensing is unstable because of functional
degradation.
- This occurs when the steam function does not
operate normally.
- This error does not occur in existing drum products.
Check whether the product is a steam model
- Heater engagement fault (out of place)
- The air hose is out of place and water leakage occurs
during the spin cycle.
- The tub back at the safety bolts fixing part is broken.
- Water leakage occurs at the front with foaming
because of too much detergent
- Water leakage occurs because the connecting hose
to the detergent drawer is connected incorrectly.
- The drain pump filter cover is engaged incorrectly.
- Water leakage occurs at the drain hose.
- The duct condensing holding screws are worn.
- The nozzle-diaphragm is engaged in the opposite
direction or the rubber packaging is omitted.
- Water leakage occurs because the screws that
hold the tub back and front in place are fastened
incorrectly.
- The leakage sensor is faulty.
- Water is supplied continually because the water level
detection does not work.
- Because the drain hose is clogged and there is
an injection error (at a narrow section), the water
level detection does not work and water is supplied
continually.
- Water is supplied continually because of freezing or
because there is foreign material in the water supply
valve.
- This error may occur when the water level sensor is
degraded.
- The washing heater in the tub has an error. (Contact
error, temperature sensor fault)
- The connector is connected incorrectly or is
disconnected.
- If the water level sensor operates without water
because the water is frozen or for any other reason
and the temperature sensor engaged at the bottom to
prevent overheating for the washing heater detects a
temperature of 100 to 150 ˚C, the washing machine
turns the input power off.
Causes
lightly. The washing machine will operate normally.
Remarks
If the heater has
no error, this
occurs because
of a PBA relay
malfunction.
This error occurs
because the
water level
sensor terminal
is out of place.
Heater sensor
fault
: When the
connector is
connected
incorrectly or
has a wire
disconnected or
contact error