Samsung WF42H5000AW Service Manual page 17

Part
Noise filter
WATeR LeveL
SeNSoR
(The Hook type)
Figure
The Hook type water level sensor
Water valve
► Disassembly
1. Separate the Top Assy-Plate.
Sensor pressure
1. To remove the water lever sensor, push it slowly
A
2. While a force is imposed on the water lever sensor
3. Impose a force slowly in the direction of the arrow
B
► Assembly
1. Connect the pressure hose to the body of the
2. To reattach the water level sensor, insert the hook
Description
in the direction of the arrow shown in the figure on
the left.
Since this disassembly method uses the
elasticity of the water level sensor hook,
imposing too strong a force may damage it.
as directed in step 1, pull the hook
direction of the arrow until it is removed from the
bracket spring.
designated in the figure on the left until the hook
is removed. Then remove the water level sensor.
water level sensor and lock it using the clamp.
When connecting the water level sensor to the
set, make sure to connect it after draining water
by operating the spin cycle.
back into the square hole until you hear a "click".
Removal and Reassembly _ 15
in the
A
B