Table of Contents
Advertisement
3.6. Restoring default settings in the controller (DEFAULT function)
Restoring default settings of the controller leads to the following information being deleted from its
memory:
network, to which SECONDARY controller has been added;
•
devices in the network for PRIMARY controllers;
•
devices associated with pairs of buttons for PRIMARY and SECONDARY controllers.
•
After performing DEFAULT procedure the SECONDARY controller will be set as PRIMARY.
1. Within 1.5 sec. press:
- "In/Ex" button twice (1) and then
- „FK" button (2) once
Figure 7: Restoring default settings in controller
3.7. Removing SECONDARY controller from the network
Removing this controller from the network consists in restoring default settings with the use of DEFAULT
function.
4. Technical parameters
11.09.21 NC826
x1
2
1
x2
Technical parameters
Power supply
Working temperature
Working range
Working frequency
2. The controller is signalizing restoring default
settings – buttons flashing for 2-3 sec. as
presented in the drawing.
CR2450, 3V DC
(+5
C) to (40
O
Up to 40 [m]
868,43 MHz
10/16
C)
O
©2011, FAKRO
Advertisement
Table of Contents
