Advertisement
13. Connect the pump to a proper power source. Fig. 13
CARE AND MAINTENANCE – PUMP
•
Clean the pump regularly depending upon the environment in which it is operated. Clean the pump
when it is visibly soiled or when a drop in performance is detected.
•
Before cleaning, always disconnect the pump from the power source.
•
Remove all parts from the pump and clean in warm, soapy water.
•
Disassemble the pump cover and remove the impeller cover to expose the impeller assembly. Use
a soft cloth or brush to clean the impeller assembly and the inside of the impeller housing. Refer to
the diagram in the replacement parts list.
CARE AND MAINTENANCE – SPILLWAY
•
Clean the spillway regularly depending upon the environment in which it is operated. Clean the
spillway when it is visibly soiled or when a drop in performance is detected.
•
Before cleaning, always disconnect the pump from the power source.
•
Use a dryer brush to clean the inside of the spillway. We recommend using a
approximately
TROUBLESHOOTING
If the light fails to illuminate:
•
Check that it is getting power by testing another appliance in the same power outlet.
•
Check to make sure the spillway is properly connected to the pump.
If the pump fails to operate:
•
Check to make sure the power cord is plugged in and the pump is getting power.
•
Check the pump outlet and any tubing, for kinks or obstructions.
•
Remove the inlet screen and/or pump cover, and impeller cover to expose the impeller. Turn
the impeller to ensure that it is not broken or jammed. Also check to make sure that the
ceramic shaft or bearings are not broken.
If the performance of the spillway is not satisfactory or does not flow evenly:
•
Check to make sure the pump is completely submerged in water.
•
Check to make sure the impeller and the housing are clean.
•
Check to make sure the spillway is clean.
0.2"
thick or any brush that will fit inside the front of the spillway opening.
GFCI
Fig. 13
1"
long brush,
Advertisement
