Advertisement
WARNINGS AND CAUTIONS – PUMP
WARNING
•
Risk of electrical shock. This pump is supplied with a grounding conductor and grounding–type
attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly
grounded, grounding-type receptacle.
•
Do not exceed the voltage shown on the pump.
•
Always disconnect pump from the power source before beginning any maintenance or work on the
pump.
•
Inspect cord for damage before installation and/or maintenance. Replace the entire pump assembly if
damage is found.
•
Do not remove the grounding pin from the power cord plug.
•
Risk of electrical shock: This pump has not been investigated for use in swimming pools or marine
areas.
CAUTION
•
This pump has been evaluated for use with fresh water only.
•
Use a proper power source as indicated on the pump label.
•
Keep the cord away from high temperatures or other heat sources.
•
Do not pump heated liquids.
•
Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
•
Operate in fresh water only. Avoid heavily chlorinated water and water with high pH levels.
•
Do not lift the pump by its power cord.
WARNINGS AND CAUTIONS – SPILLWAY
WARNING
•
To reduce the risk of fire or injury, keep spillway away from materials that may burn.
•
Always disconnect spillway from the power source before beginning any maintenance or work on the
spillway.
•
Inspect cord for damage before installation and/or maintenance. Replace the entire spillway if damage
is found.
CAUTION
•
Keep the cord away from high temperatures or other heat sources.
•
Do not lift the spillway by its power cord.
•
This spillway is not intended for use in swimming pools or hot tubs.
PREPARATION
Before beginning assembly or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
•
Estimated Assembly Time: 15 minutes
•
Tools required for assembly: flathead screwdriver, hacksaw.
OPERATION INSTRUCTIONS
1. Select a level location to assemble the Patio Pond. Then place the
pump inside the basin, route the cord of the pump between the liner
and the inside wall of the fabric, so it will not be visible from the
outside of the unit. Fig. 1
Fig. 1
Advertisement
