Important Safeguards; Installation; Inspection; Electrical Requirements - Ultrasonic P500 Operation & Maintenance Manual

IMPORTANT SAFEGUARDS

Read before installing or using the equipment
Your Ultrasonic Welding System has been de-
signed with safety in mind. However, no design
can completely protect against improper usage,
which may result in bodily injury and/or property
damage. For your protection and equipment safe-
guard, observe the following warnings at all times,
read the operating instructions carefully before
operating the equipment, and retain this instruc-
tion manual for future reference. If the Ultrasonic
Welding System is used in a manner contrary
to that specified in this instruction manual, the
protection features designed into the unit may be
impaired.
• High voltage is present in the power supply.
Do not remove the cover. Refer all servicing to
qualified service personnel.
• Never operate the power supply unless it is
connected to the hand gun (converter).
• Never secure anything to the tip.
4

INSTALLATION

Inspection

Prior to installing the Ultrasonic Welding System,
perform a visual inspection to detect any evidence
of damage, which might have occurred during
shipment. Before disposing of any packaging
material, check it carefully for small items.
The Ultrasonic Processor was carefully packed and
thoroughly inspected before leaving our factory.
The carrier, upon acceptance of the shipment,
assumed responsibility for its safe delivery. Claims
for loss or damage sustained in transit must be
submitted to the carrier.
If damage has occurred, contact your carrier
within 48 hours of the delivery date. DO NOT
OPERATE DAMAGED EQUIPMENT. Retain all
packing materials for future shipment.

Electrical Requirements

The Ultrasonic Processor requires a fused, single
phrase electrical outlet capable of supplying
60 Hz at 110 volts or optional 220 volts. Contact
Ultrasonic Poultry Systems for the right plug for
your region.

Safety

Operating the equipment with voltages different
from those specified, or with voltages with high
power transients, will cause components within
the power supply to fail.
Preparation for Use
1. Plug the electrical line cord into the electrical
outlet, MUST HAVE A GROUND CONECTION.
if the unit is already on; depress the key.
2. If the converter / horn assembly is not already
assembled; screw the horn onto the converter
and secure with wrenches provided.
3. Connect the converter cable to the
power supply.
4. The following pages show standard horns.