Champion CHTW200 User Manual page 4

Operations
How to pair
NOTE: The left and right headsets will automatically connect after power on in factory. The left
EN
headset for pairing will be the master headset while sub-headset for the right one.
1. Keep your mobile phone close to the device. Suggested distance is less than 1 meter.
2. Press "Multi Function" button of the left and right headset for 1 second, the blue LED will
turn on, then the left and right headsets will automatically connect.
3. Turn on the Bluetooth application on your mobile phone and click to search Bluetooth
devices near your mobile. Once searched "CHWC200" device name, select it to pair.
After completely paired, blue LED will turn on and voice prompt "Pairing successful, Second
device connected".
Power on / Pairing
Power off
Play
Pause
Re-dial last phone num-
ber
Answer phone call
Reject phone call
Cradle charging
1. After putting headsets into the cradle, please click the cradle of charging button. On the
edge of USB LED of cradle will show red once charging has started. Once fully charged,
the LED will show blue.
2. The red LED on the edge of cradle will blink slowly when low battery.
3. The cradle can fully charge the headsets up to 3 times.
4. If the cradle and headsets are charged by USB outlet, here is no need to press the headset
charging button. They will be charged automatically.
5. The four LED in the front of cradle is the battery capacity indication light, each light shows
25% power. Long Press the cradle charging button will display the battery capacity of
cradle.
Notice
If you fail to connect the headset with your mobile phone, please follow the below suggestions and
instructions:
Press "Multi Function" button of the
headsets for 1 second at the same
time
Long Press "Multi Function" button
on one of the headsets for 5
seconds
Click "Multi Function" button on
either one of the headsets
Click "Multi Function" button on
either one of the headsets
Double click "Multi Function"
button on either one of the headsets
(without music playing mode)
Click "Multi Function" button either
of the headset when incoming call
Double click "Multi Function" button
either one of the headsets when
incoming call
Blue LED starts, and voice
prompt "Pairing successful,
second device connected"
Red LED glitters twice, and
voice prompt "power off"