Modifications And Changes To The Machine - Gardner Denver L160 110A V2 User Manual

Weight / lifting gear
Carefully attach and secure heavy individual
components and assemblies when replacing,
so that they do not present a hazard. Use only
suitable lifting gear that is in technically perfect
condition, and a load handling device with
sufficient load capacity. Do not stand or work
beneath suspended loads.
Spare parts
Use only original spare parts.
Spare parts must comply with the technical
requirements stipulated by the manufacturer. This
is guaranteed only when original spare parts are
used.
After completing maintenance and repair
work
After maintenance and repair work is completed,
ensure that no tools, loose parts, or rags have
been left behind in the compressor (particularly in
the drive motor or the drivetrain).
Rotate the drive several times in order to make
sure that there is no mechanical fault in the
compressor or the drivetrain.
Tighten all bolt connections that were loosened for
the maintenance and repair work. Also check all
the other bolt connections.
Before releasing the compressor for operation
after maintenance and repair work, ensure that
the operating pressures, temperatures, and time
settings are correct, and that the control and
shutoff device work perfectly.
If safety or protective devices must be removed,
then they must be re-installed and checked for
perfect function immediately after completing the
work.
2.10 Modifications and changes to
the machine
Do not make any modifications, additions, or
reconfigurations of the compressor without prior
consultation with Gardner Denver.
Unauthorized changes to the machine are not
allowed for safety reasons.
Original parts are specially conceived for the
machine. We explicitly give notice that parts and
special equipment not provided by us are also
not approved by us. The installation and/or use of
such products can therefore degrade active and/or
passive safety.
January 2017
Damage arising from the use of non-original parts
or special equipment precludes the liability of the
manufacturer. This also applies to the installation
and adjustment of safety devices and valves, and
for the welding of load-bearing or pressurized
parts.
America
Safety requirements
15 /72
2