EMS FireCell FCX-174-001 Installation Manual

Wireless Detector
Installation Guide
1 Pre Installation
Installation must conform to applicable local installation
!
codes and should only be installed by a fully trained
competent person.
Ensure that the device is installed as per the site survey.
The use of a non-metallic spacer should be considered if
mounting the device on to a metal surface.
Do NOT Press the Log On button on a pre-programmed
device, as this will cause communication with the Control
Panel to be lost. Should this happen, delete the device from
the system and add it back on.
3 Fix Mounting Plate
Remove the mounting plate from the wireless module by turning
it anticlockwise.
Use both mounting holes to ensure a firm fixing.
Use suitable fasteners and fixings.
5 Optional Device Locking
To lock the wireless module
into the mounting plate, insert
a 1.5mm Allen key into the
allen key slot and
clockwise as shown.
The detector can also
locked into the
module. To do so, prior to
refitting the detector, remove
the cut out (shaded) section
as shown.
©2020 EMS Ltd. All rights reserved
Example shown:
www.emsgroup.co.uk
Radio Detector Base
FCX-177-001
IDENT
PRESS HERE TO
LOG ON
FCX-170-001
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE
63mm
turn
be
wireless
Part No Product Description
FCX-170-001 Wireless Detector Base Only
FCX-174-001 Multisensor Smoke Detector Only
FCX-175-001 Heat A1R Detector Only
FCX-176-001 Heat CS Detector Only
FCX-177-001 Optical Smoke Detector Only
See the Specification section for compliance information.
2 Components
1
1
Dust Cover
4
Battery Retaining Plate
4 Power Device
Unclip the battery retaining plate from the wireless module.
When fitting / replacing batteries; observe correct polarity,
using only specified batteries.
Connect the power jumper across the PIN header.
SIZE AA
SIZE AA
SIZE AA
SIZE AA
SIZE AA
SIZE AA
Once powered, reassemble the device.
6 Device Unlocking
To unlock the detector from
the wireless module, insert a
1.5mm Allen key and lever the
Allen key towards the outside
of the device whilst turning the
detector anticlockwise
release as shown.
To unlock the wireless module
from the mounting
insert a 1.5mm Allen key and
turn anticlockwise to release
as shown.
Page 1 of 2
3
2
2
3
Detector Wireless Module
5
Mounting Plate
unpowered
(pins unlinked)
(both pins linked)
to
plate,
TSD044 Iss 14 14/10/2020
CPR
[3]
[4]
[1]
[1]
[2]
4 5
device
device
powered
AJM