Advertisement
5.6
Taking out a disc
5.6.1 Method 1
There is compulsive tray ejection mode by electric operation.
(1) AC Plug is pulled out at once and inserted again.
(2) It is displayed on FL display as "LOADING", and while it blinks, pushing the EJECT button of a main body is continued.
(3) After a while, a tray opens (About 20 seconds).
(4) A disk is removed, the EJECT button of a main body is pushed, and a tray is made to close.
(5) The "LOADING" blink display of FL display disappears and it will be in a standby state.
(6) If the POWER button is pushed, it will usually be operating.
5.6.2 Method 2
When a disk is not able to be taken out by operation of "Method 1"
A tray can be ejected mechanically, without switching on a power supply.
(1) A mechanism drive is removed from a main body.
(2) The part a on the reverse side of a mechanism assembly is made to slide in the direction of an arrow with a driver etc.
(3) Since a tray ejects a few, a tray is pulled out manually.
5.7
Initialization to a factory-shipments state
Since the information on internal is as follows if it initializes, before enforcement, it is required to surely obtain the approval of a end
user.
• All the libraries of DVD are eliminated.
• All initial setting of DVD returns to an initial state.
(1) Set the main body to JIG mode.
(2) Transmit "43-6F" to the main body by using JIG remote control unit.
(3) It is displayed on FL display part as "FACTORY", and it is set to "CHECK OK" after blinking for a while.
(4) A power cord is extracted.
(5) Since JIG mode is canceled compulsorily, please insert a power cord again and, simultaneously with operation of this initializa-
tion, check that JIG mode is canceled. (The colon of a clock display be on)
1-18 (No.XA019)
Part a
Advertisement
