Respekta MW 800 Operating And Installation Manual page 39

Please Read the Manual Carefully Before Installation
Please note
Electrical connection
The oven is fitted with a plug and must only be connected to a properly installed earthed
socket. The socket must only be installed and the connecting cable must only be
replaced by a qualified electrician, and in accordance with the appropriate regulations.
If the plug is no longer accessible following installation, an all pole isolating switch must
be present on the installation side with a contact gap of at least 3 mm.
The fitted cabinet must not have a back wall behind the appliance.
A gap must be maintained between the wall and the base of the unit above.
Specific gap size could be referenced by the diagrams.
Minimum installation height: 85 cm.
Do not cover ventilation slots and suction holes.
Note:
Do not trap or bend the power cable.
Screw A
Screw B
Mounting Plate
Trim-kit plastic cover
Installation Instructions
12