Table of Contents
Advertisement
PREPARING THE UNIT FOR INSTALLATION
A sturdy single-piece mounting bracket is used to frame the
installation location and secures the unit to the wall studs. The
bracket has been designed to hold the unit at a two-degree (2°)
angle. This helps project air into the space and aids in condensation
drainage.
Applying Insulation Tape
Locate the six-foot piece of black foam tape included with the unit.
Align one end of the foam tape with the upper left corner of the
rear side of the mounting bracket. Stretch the tape across the rear
of the bracket and cut the tape at the opposite edge. Peel off the
white paper backing and attach the cut piece of foam tape to the
top rear side of the mounting bracket. Follow the same procedure to
place a piece of tape on the bottom edge of the mounting bracket.
Place the remaining piece of foam tape on one side of the mounting
bracket (spanning the distance between the pieces of tape on the
top and bottom edges of the mounting bracket), then cut, remove
paper backing, and secure. Do the same on the opposite side of the
bracket. Discard any excess. The foam tape will create a tight seal
between the bracket and the wall.
Mounting Bracket Installation
Select your desired bracket mounting location (see diagram below). This location determines the depth of the installation. For
example, position #1 keeps most of the unit out of the cellar while position #4 sets the back of the unit near flush with the
exterior wall. Slide bracket onto unit. Ensure that the TOP label on the bracket and the unit mounting flanges are towards the
back. Use the four supplied 1/2" pan-head screws to fasten the bracket to the unit. It is imperative that you use screws no longer
than 1/2" in length.
If you are installing through an exterior wall, please review the
next page for specific instructions on exterior grill installation.
Wine Cellar
#1 7.5–9.5" In Cellar
#2 11.5–13.5" In Cellar
#3 15.5–17.5" In Cellar
#4 19.5–21.5" In Cellar
5" inch thick wall
(wall thickness may vary)
Ultimate Series
1
3
2
Mounting Bracket
Exhaust Area
www.cellarcool.com | Page 13
4
Advertisement
Table of Contents
