Makita DBO480 Instruction Manual page 9

7. Maintain a proper tension on abrasive paper, and then
set the clamp lever on the other end in a locked position.
2
1
4
3
2
1
3 4
Fig.9
► 1 . Abrasive paper 2. Clamp 3. Sanding base
4. Clamp lever 5. Stopper
8. To remove the abrasive paper, release the clamps
on both ends and take the paper off the pad.
Using hook-and-loop abrasive paper
CAUTION:
Make sure to install a hook-and-
loop pad correctly and securely. A loose attach-
ment will run out of balance and cause an excessive
vibration resulting in loss of control.
CAUTION:
Be sure that a hook-and-loop pad and
abrasive paper are aligned and securely attached.
CAUTION:
Only use hook-and-loop abrasive
papers. Never use pressure-sensitive abrasive papers.
For DBO480
1. Remove all dirt and foreign matter from the hook-
and-loop pad.
2. Attach a sheet of optional hook-and-loop abrasive
paper to the pad, aligning the dust-suction holes in the
paper with those in the pad.
1
2
Fig.10
► 1 . Abrasive paper 2. Pad 3. Dust-suction holes
5
5
3
To remove the abrasive paper, peel it off from the
3.
edge.
For DBO481 and DBO482
NOTICE:
The cap or the O-ring may come out of
the sanding base while replacing the pad. Be sure
to set the cap or the O-ring back in the circular
hole or the circular groove around the center of
the base before installing the optional pad.
DBO481
2
Fig.11
► 1 . Cap 2. Sanding base 3. Circular hole
DBO482
2
Fig.12
► 1 . O-ring 2. Sanding base 3. Circular groove
1. Loosen and remove the four screws securing the
pad to the sanding base.
Fig.13
► 1 . Screws 2. Pad 3. Sanding base
9 ENGLISH
1
3
1
3
1
2
3