Remington Omniblade Face & Body HG3000 Manual page 6

ENGLISH
TO TRIM THE BEARD
1. Select your desired trimming length comb. If you are trimming for the first time start
with the maximum trimming length setting.
2. Turn the unit on.
3. Place the flat top of the fixed comb against the skin.
4. Slowly slide through the hair. Repeat from different directions as necessary.
5. If hair builds up in the trimmer comb during the trimming process, switch the unit off,
pull off the comb and brush the hair off.
TO GET A SHAVEN LOOK
To trim any length of beard or stubble hair for a clean, shaven look then follow the above
steps without a comb attached to the blade head.
Place the flat top of the blade against the skin and slowly slide through the hair against the
direction of growth.
Shave in an upwards direction when shaving under the chin (Fig. A).
TRIMMING AND EDGING
1. Hold the device with the back side of the blade facing you with no combs attached.
2. Start with the blades resting lightly against your skin, use motions towards edge of
beard line to trim to desired locations in facial area.
3. Shape as desired.
TRIMMING WITH SHAVING GEL
Follow the same instructions as dry shaving if using shaving gel.
Caution: After use with shaving gel, please rinse the blade under warm water to clean away
any excess gel and debris.
BODY HAIR MAINTENANCE
Attachments
Body blade attachment
Body hair maintenance: Trimming to length
1. Fit the body blade attachment.
2. Body hair can be trimmed to 3 different lengths (3, 6 and 9 mm). Select the desired length
by sliding the comb into one of the three slots on the side of the attachment (Fig. D).
3. Place the flat side of the attachment against the skin.
4. Slowly slide the trimmer through the hair in the direction of hair growth.
5. Use slow, well-controlled movements.
Body hair maintenance: Removal
1. Remove the comb from the body blade attachment and go over the areas where you
want to remove the body hair.
2. Stretch the skin with your free hand to make the hairs stand upright.
3. Use light pressure and shave against the direction of hair growth.
6