Datalogic BA100 Instruction Manual page 54

CBX800 INSTALLATION MANUAL
COMPLIANCE
POWER SUPPLY
This product is intended to be installed by Qualified Personnel only.
This device is intended to be supplied by a UL Listed NEC Class 2 power source.
Total power consumption is given by adding the CBX800 power consumption to that of all the
devices powered through the CBX800 (reading device, P.S., I/O). Refer to the manual of the
connected devices for details about minimum/maximum supply voltage and power
consumption.
CAUTION
Each CBX800 supports only 1 single reading device on the 25-pin connector + system accessories.
CE COMPLIANCE
CE marking states the compliance of the product with essential requirements listed in the applicable European
directive. Since the directives and applicable standards are subject to continuous updates, and since Datalogic
promptly adopts these updates, therefore the EU declaration of conformity is a living document. The EU
declaration of conformity is available for competent authorities and customers through Datalogic commercial
reference contacts. Since April 20
inclusion of an adequate analysis and assessment of the risk(s). This evaluation was carried out in relation to the
applicable points of the standards listed in the Declaration of Conformity. Datalogic products are mainly designed
for integration purposes into more complex systems. For this reason it is under the responsibility of the system
integrator to do a new risk assessment regarding the final installation.
Warning: This is a Class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
FCC COMPLIANCE
Modifications or changes to this equipment without the expressed written approval of Datalogic could void the
authority to use the equipment.
This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference which may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
EAC COMPLIANCE
Customs Union:
The CU Conformity certification has been achieved; this allows the Product to bear the Eurasian mark of
conformity.
34
th
, 2016 the main European directives applicable to Datalogic products require