Page 1
Owner’s Guide For Models: PR1BZ PR1BZLR PRORS RF Upgrade Kit IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply.
Table of Contents Using Your Remote Control ..............3 Locking the Vehicle Doors ..............3 Arming the Security System .............. 3 Unlocking the Vehicle Doors ............. 3 Disarming the Security System ............3 Two Stage Door Unlock (optional) ............. 3 User Selectable Notification Chirps ...........
Using Your Remote Control Door Lock To lock the vehicle doors press and release the button. Arming the Security System (Optional) To arm the system, exit the vehicle, close all doors, then press the button. The parking lights will flash 1 time, indicating the system is armed, has locked the doors (if equipped and connected) and activated the starter disable feature.
User Selectable Notification Chirps System ARM/DISARM chirps can be toggled ON or OFF without entering the programming feature banks. Turn the ignition ON then OFF. Press and release the valet/programming button 3 times. The system will respond with 1 chirp for ON or 2 chirps for OFF. User Selectable LED This feature will control whether the LED is ON or OFF when the system is Armed/ Locked and can be toggled ON or OFF without entering the programming feature...
Using Your Remote Starter Remote Starting Your Vehicle To activate the remote start function, press and hold the button for 3 seconds. The system will sound, the parking lights will flash 1 time and the system will check the vehicle to ensure it is safe to start. If all safety parameters are correct, the vehicle will start.
Remote Start Ready Mode must be enabled if your vehicle is equipped with a manual transmission. Remote Start Ready Mode - Manual Transmission Vehicles Only To activate the remote start function, the system must first be in Remote Start Ready Mode.
Cancelling Remote Start Ready Mode - Manual Transmission Vehicles Only The system will exit remote start ready mode if any of the following occur: Open any door Open the hood or trunk (if connected) Press the brake Release the parking brake Turn the ignition ON Using the “Quick-stop”...
Status LED, Light Flashes, and Siren/Horn Indications Status LED Flash Indications LED Flashes Function Disarmed Slow Flash Armed Fast Flash Passive Arming Countdown ON (Solid) Valet Mode 1 Flash / Disarmed Zone 1 Trigger, Shock Sensor 2 Flashes / Disarmed Zone 2 Trigger, Trunk / Hood 3 Flashes / Disarmed Zone 3 Trigger, Door...
Replacing Remote Control Batteries 1 Button Remote Control - Model 181BPR / 181XPR The CR2032 battery inside each remote control should last approximately 1 year under normal use. When the batteries become weak you will notice the remote control range (the distance from the vehicle the remote control will work) deteriorate and the small LED on the remote control will dim.
LIMITED LIFETIME WARRANTY Applies to Pursuit Series Control Modules, Sirens, Sensors, and Relays. Voxx Electronics Corporation (the Company) warrants to the original purchaser of this product that should this product or any part thereof, (other than transmitters) under nor- mal use and conditions, be proven defective in material or workmanship during the life-...
Page 11
Voxx Electronics Corporation. Customer Service 1-800-225-6074 WWW.ADVENTPRODUCTS.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.
Need help?
Do you have a question about the PR1BZ and is the answer not in the manual?
Questions and answers