Page 1
Owner’s Guide For Model: PE5BZ Flashlogic FLRSBA RF Upgrade Kit IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply.
Page 2
Table of Contents Using Your Remote Control ............3 Remote Start Valet Mode ............4 Remote Control Programming ...........5 Replacing Remote Control Batteries ........6 2018 Voxx Electronics Corporation. All rights reserved.
Page 3
Using Your Remote Control Door Lock To lock the vehicle doors press and release the button. Door Unlock To unlock the vehicle doors press and release the button. Two Stage Door Unlock (Optional) If this feature is enabled on your system, pressing the button one time will unlock only the driver’s door.
Page 4
Entering the Vehicle while it is Running via Remote Vehicle Start Unlock the vehicle’s doors. Enter the vehicle. DO NOT PRESS THE BRAKE PEDAL! Insert the key into the ignition switch and turn to the ON or RUN position. Press the brake pedal. The remote vehicle starter will disengage and the vehicle will operate normally.
Page 5
Remote Control Programming Cycle the vehicle ignition ON. Press and release the Valet button 3x. Press 1 button of each transmitter you wish to program, the LED’s will flash to confirm each transmitter. Turn the vehicle ignition OFF. NOTE: This system has 1 button programming which programs all channels of the system.
Page 6
Voxx Electronics Corporation. Customer Service 1-800-225-6074 www.AdventProducts.com FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.
Need help?
Do you have a question about the PE5BZ and is the answer not in the manual?
Questions and answers