Bosch HDD80051UC Installation Instructions Manual page 21

INSTALLATION
Plug electrical panel
Plug electrical panel cable into lower receptacle on side of
downdraft.
Connect downdraft to power
1. Plug the downdraft's power cord into the 3-pronged
receptacle. Make sure that the power cord is routed away
from the heat generated by the cooktop.
2. Check operation.
3. Remove all protective Þ lm and packaging before operation.
In order to remove all protective Þ lm and packaging, raise
the intake housing and remove the front panel to access
the Þ lter area.
Install cooking appliance
Align the cooking appliance with downdraft and fasten
appliance in place following appliance instructions.
Note: Accurate alignment of cooking appliance and
downdraft is necessary to ensure that there is no
interference when air vent is raised and lowered. There
should be a gap of 1/32" - 1/16" (0.79 mm - 1.59 mm)
between the back of the cooktop and the front of the
downdraft cover.
All manuals and user guides at all-guides.com
Attach endcaps to downdraft
NOTE: Following procedure applies to both endcaps.
1. Use the included special key to loose the endcap
2. Place the endcap over the bracket.
3. Use the included special key to tighten the endcap
4. Check the operation of the downdraft.
SPECIAL KEY
(INCLUDED )
retaining screw.
retaining screw.
ENDCAP
RETAINING
SCREW
English 21