Page 1
600 Yard Trainer GDT00-16645 | Product Manual 6 0 0 Have questions about your 600 Yard Trainer or need training tips for your pet? Our Customer Care representatives are here to help you. Call our USA-based Customer Care Center at +1 (866) 381-2785 USA &...
Hereinafter Radio Systems Corporation and any other affiliate or Brand of Radio Systems Corporation may be referred to collectively as “We” or “Us”. IMPORTANT SAFETY INFORMATION Explanation of Attention Words and Symbols used in this Product Manual This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
Remote Training Collar How it Works The Premier Pet 600 Yard Trainer can be used to both stop bad behaviors and teach your dog ™ good behaviors. The trainer has tone (beep), vibration, and 99 levels of static simulation. The easy-to-use design only requires a press of the action button, and the signal is sent to the collar.
Make sure that the collar is turned off. Start with your dog standing comfortably. Place the collar on your pet so that the Premier Pet logo ™ is right side up and the collar is directly under your dog’s chin.
Charge the Collar & Remote Excessive charging can shorten battery life. Only charge your remote or collar when the batteries are low. Lift the cover protecting the charging port and connect the charger to the collar and/or remote. Plug the opposite end of the charger into a compatible charging port. Plug in and fully charge the remote and the training collar.
• Move up through the static stimulation levels until your pet reliably responds to the stimulation. • If your pet continues to show no response at level 99, check the fit of the training collar. You might also want to test it on your hand at a lower level to ensure the collar is working. If all of these steps have been done and your pet continues to show no reaction to the stimulation, please contact our Customer Care Center.
Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Need help?
Do you have a question about the GDT00-16645 and is the answer not in the manual?
Questions and answers