Koldfront KIM450BL Owner's Manual page 19

Issue
The machine won't
operate.
The water doesn't feed in
after the icemaker starts.
The machine makes ice,
but the bin does not fill up
with ice.
Water is leaking out of the
unit.
The ice cubes are partially
formed or are white at the
bottom.
There is noise during
operation
The icemaker stops
suddenly while making ice.
The body of the ice maker
is electrified.
Scale Builds up quickly
inside the machine.
Possible Cause
The icemaker is unplugged.
The breaker is tripped.
The icemaker power switch
is OFF.
The ice storage bin is full of
ice.
The water supply tap is
turned off.
The water supply pipe is not
properly connected.
The condenser may be dirty.
The air flow to the ice maker
may be obstructed.
The ambient temperature
and water temperature are
high, or the unit is close to a
heat source.
A few water droplets are on
the door.
The water supply connection
is leaking.
The unit is not level.
There is not enough water in
the water bin.
The unit is not level.
Certain sounds are normal.
The electricity is off.
The room temperature is out
of the stated range.
The ground line isn't in the
socket.
The calcium level in the
water is too high.
15
Solution
Plug the icemaker in.
Reset the breaker.
Switch the icemaker power switch to
ICE (ON).
Take away some ice cubes and make
sure the ice-full probe is free of ice.
Turn on the water supply tap.
Reconnect the water supply pipe.
Clean the condenser.
Check the installation. See the
"Installation" section.
Check the installation. See
"Installation" section of this manual.
Under some conditions, humidity may
condense on the door. Consider
moving the unit or just be more
careful when you open the door.
Tighten the fitting. See the
"Connecting the Water Line" section.
Level the feet. See the "Leveling the
Ice Maker" section.
Check if the water supply pressure is
below 15 PSI.
Check the water supply. The filter
may be restricted.
Check for a water leak in the water
trough.
Level the feet. See the "Leveling the
Ice Maker" section.
See the "Normal Sounds" section.
Reconnect the power supply line.
Make sure unit is installed with correct
clearances and within the stated
ambient temperature range. See
"Installation" section of this manual.
Use the correct plug and outlet.
Use a water filter installed in front of
the water inlet valve.