Azimuth Adjustment; Needle Replacement; Turntable Maintenance - Crosley C62 Instruction Manual

English

Azimuth Adjustment

The needle must be perpendicular to the record groove in order to track the groove wall
modulations correctly. In rare cases, if the factory installation is not perfect, you can make below
adjustment:
1. Use an Allen Wrench to loosen the screw located at the bearing end of the tonearm just
enough to loosen the arm tube.
Note: Do not remove the screw completely.
Gently rotate the tonearm until the needle is perpendicular to the record surface.
2.
Note: Make sure the needle tip is not touching the record when adjustment is being made or it will cause
damage to the needle and cantilever suspension.
3. Tighten the screw when adjustment is finished.

Needle Replacement

Removing Needle
1. Gently pull down the front edge of the needle.
2. Pull needle forward.
3. Pull out and remove.
Installing Needle
1. Position the needle with its tip facing down.
2. Line up the back of the needle with the cartridge.
3. Insert the needle with its front end at a downward angle and gently lift the front of the needle upward until it snaps into
place.

Turntable Maintenance

1. Do not touch the stylus tip with your fingers. Avoid bumping the stylus on the turntable mat or a record's edge.
2. Clean the stylus frequently with a soft brush with a back-to-front motion only.
3. Clean the records to get rid of dust or grease with a record cleaning brush and record cleaning solution.
4. Clean the turntable lid and turntable cabinet with a slightly damped microfiber cloth.
Note: Do not use cleanser that contains alcohol, benzene or any other harsh chemicals, which might damage the paint and finish of the
turntable.
** Crosley offers a product line of different cleaning accessories. Please ask your retailer or check out our
website www.crosleyradio.com for more cleaning product information.
7