Table of Contents
Advertisement
installation
17. Attach the toe panel mounting brackets to the
toe panel. Align the screw holes, then use the
4 screws ST4x14 to secure the toe panel.
18. Insert the toe panel to the dishwasher.
19. Make sure your plumbing is suitable for
use with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS using
the new water inlet hose. OLD HOSE SETS
MUST NOT BE RE-USED. The water
pressure from the water mains needs to be at
a minimum of 0.04 MPa and a maximum of
1.00MPa.
• Connect one end of the safety water
supply hose to your dishwasher, and then
connect the other end of the hose to your
water mains. Please ensure the black
rubber seal is in place.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
You may use a Y-Adaptor (not
included) for an additional water
feed for another appliance, for
example a washing machine. This
is only applicable for cold water
mains. A Y-Adaptor is available
from most DIY stores.
14
Water mains
Y-Adaptor
(not included)
Water supply hose
About the Safety Supply Hose
The safety supply hose consists
of the double walls. The hose's
system guarantees its intervention
by blocking the flow of water in
case of the supply hose breaking
and when the air space between
the supply hose itself and the outer
corrugated hose is full of water.
Connect
to another
appliance if
required.
Hide quick links:
Advertisement
Table of Contents
