Setup And Special Configurations - Midland BTMESH Instruction Manual

› Double click on the "Middle" button to exit the "Setup" mode and use the
Midland BTMESH.
Enabling:
› Follow the same procedure just described; now the blue LED will flash
once.
To exit the "Setup" mode, double click the "Middle" button.
FM Radio and intercom
When you are in "FM Radio" mode it is possible to manually open the in-
tercom, just Double clicking on the FORWARD or BACKWARD button
dipending where you made the pairing. You can also open it using the VOX
feature (just talk) to the unit paired on the "Backward" button.
FM Radio and Mesh
When you are in "FM Radio" mode it is possible to manually open/close the
Mesh, just Double clicking on the MIDDLE button .
FM Radio in background to Mesh
If you turn on the FM radio when the Mesh communication is open (just open
the Mesh and then move to FM radio mode), the FM radio and Mesh are
both available. In this way you can be always in touch with your group while
you enjoy the FM radio. In case you need to have the Mesh audio alone, just
turn off the FM radio with one click on the MIDDLE button.
FM Radio in background to Intercom
If you move to FM Radio mode when an Intercom communication is open,
the Intercom will be closed. If you are already in FM radio mode and you
open the Intercom by VOX (or with double click on FWD or BWD button)
or someone will open the Intercom to you, the FM will be available together
with the Intercom.
In case you need, while the Intercom is open, you can always turn off the FM
radio with one click on the MIDDLE button.
Attention: Any active audio coming from the "Vol+" or "Vol-" connection, will
always pause temporary the FM radio.
www.midlandeurope.com

Setup and special configurations

Resetting all paired devices
Sometimes you may find it necessary to delete all the pairing references sto-
red in the Midland BTMESH unit (reset operation).
To perform this operation you must first enter the setup mode:
› Turn off the unit.
› Press and hold down the "Middle" button about 7 sec., until the Red light
is on permanently.
› Then simultaneously press and hold down the "Volume +" and "Volume –"
buttons for 3 seconds. The Blue Light will be lit on for 1 sec and then goes
back to steady RED.
› Double click on the "Middle" button to exit the "Setup" mode and use the
Midland BTMESH.
This procedure deletes all paired Bluetooth devices stored in the memory and
it is therefore possible to start a new "clean" pairing session.
Back to factory setting
Sometimes you may find it necessary to go back to the factory setting, to
reset all the changes/setup already made and have a "clean" unit.
To perform this operation you must first enter the setup mode:
› Turn off the unit.
› Press and hold down the "Middle" button about 7 sec., until the Red light
is on permanently.
› Then simultaneously press and hold down all the three buttons "Forwar-
d"-"Middle"-"Backward" for 3 seconds. The Blue Light will be lit on for 1
sec and then back to steady RED.
› Double click on the "Middle" button to exit the "Setup" mode and use the
Midland BTMESH
These adjustements can be set through the program "BTPro Updater" sui-
table for PC/MAC
Adjusting/ Disabling the VOX feature (Intercom and telephone)
The Intercom feature can be enabled both manually and vocally (VOX). The
VOX activation is influenced by the helmet type, the background noise and
therefore by the speed.
17