Pairing The Midland Btmesh To Phone And Gps Navigator - Midland BTMESH Instruction Manual

Dual core conference system

Hide thumbs

Table Of Contents

Table of Contents

PASSENGER

Midland intercom

(not BTMESH)

ATTENTION: AVOID TO CREATE A LOOP BETWEEN TWO UNITS.

If two units are already part of a mesh group, do not pair the same two units

with bluetooth intercom because if you open both mesh connection and blue-

tooth connection with "bridge on", you will experience severe noise issues.

Universal Intercom with different brand unit

Thanks to the "Talk2 All - Universal Intercom" feature it is now possible to pair

your Midland BTMESH to a different brand intercom available on the market.

You can pair a not Midland Intercom devices on the Backward button.

› On the Midland BTMESH enter the setup mode: (with the unit OFF press

and hold down the Middle button about 7 sec. until the Red light is on per-

manently).

› Keep pressed the "Forward" button for 7 seconds: the Red and Blu LED

lights will start flashing fast, then (while you still keep the button pressed)

the Red and Blue LED lights will change to slow flashing. Now you can re-

lease the button.

Talk2All-Universal Intercom

Not Midland Intercom

www.midlandeurope.com

BTMESH

On the other intercom (not Midland brand) follow the procedure to pair to a

phone, because the BTMESH is paired as a Phone.

If successfully paired the red/blue lights will stop flashing and the blue light

will slowly flash instead.

Attention: remember to switch OFF all the other Bluetooth devices during the

pairing procedure, only the two devices involved in the pairing must be turned on.

To open the "Universal Intercom" communication on the Midland BTME-

SH while you are in "Mesh Mode", press long (3 sec) the Forward button.

On the other intercom just press the phone redial or voice dial button.

Maybe it will be necessary to press the redial button two times, depending on

the model of the not Midland intercom.

Attention: In order to use the "Universal Intercom" feature the pairing on the

other unit must be done as a phone. The other intercom (not Midland brand) will

Bluetooth to

Mesh bridge

be able to use a phone only if two phones are supported.

You can pair also a Midland unit as Universal Intercom, that means the pairing

must be done as a phone (one unit use the Universal Intercom procedure and the

other unit use the pairing to "Phone" procedure).