Servicing The Bedknife - Toro 03698 Operator's Manual

Servicing the Bedknife

The bedknife service limits are listed in the following chart.
Important:
Operating the cutting unit with the bedknife below the service limit may result in poor
after-cut appearance and reduce the structural integrity of the bedknife for impacts.
Bedknife
EdgeMax® Low HOC
(Optional)
Low HOC (Optional)
Extended EdgeMax®
Low HOC (Optional)
Extended Low HOC
(Optional)
EdgeMax®
(Models 03698 and
03699)
Standard (Optional)
Heavy Duty (Optional)
Figure 32
Recommended Top and Front Bedknife Grind Angles
1. Bedknife service limit*
2. Top grind angle
3. Front grind angle
Note:
All bedknife service limit measurements relate
to the bottom of the bedknife
Bedknife Service Limit Chart
Part
Bedknife Lip Height*
137-0832
(0.220 inch)
110-4084
(0.220 inch)
119-4280
(0.220 inch)
120-1640
(0.220 inch)
137-0833
(0.270 inch)
108-9096
(0.270 inch)
110-4074
(0.370 inch)
g027268
(Figure 33).
Service Limit*
5.6 mm 6.4 to 12.7 mm
(0.250 to 0.500 inch)
5.6 mm 4.8 mm
(0.190 inch)
5.6 mm 4.8 mm
(0.190 inch)
5.6 mm 4.8 mm
(0.190 inch)
6.9 mm 4.8 mm
(0.190 inch)
6.9 mm 4.8 mm
(0.190 inch)
9.3 mm 4.8 mm
(0.190 inch)
20
Grind Angles
Top/Front Angles
10/5 degrees
10/5 degrees
10/10 degrees
10/10 degrees
10/5 degrees
10/5 degrees
10/5 degrees
Figure 33
g007165