Advertisement
Table of Contents
- 1 WARNING: Electrical and Plumbing Connections
- 2 Drain Hose
- 3 Connect the Drain Hose to Floor Drain
- 4 Connect Dishmachine to Cold Water Source
- 5 If Necessary Adjust the Temperature
- 6 Level Dishmachine by Adjusting Leveling Legs
- 7 Turn on Power and the Machine will be Automatically Filled
- Download this manual
181-VL
Quick Setup
Instructions
WARNING: Electrical and plumbing
connections need to be made by a
qualified service technician and
comply with all available Federal, State
and Local Health, Electrical, Plumbing
and Safety codes.
HARD WIRE
FOUR WIRE
POWER SUPPLY
HOT
NEUTRAL
GROUND
1
DRAIN HOSE
COLD WATER
2
LINE
STEP
1
1"AIR GAP
FLOOR DRAIN
Connect the drain hose to floor drain. The floor
drain must have a 1 inch air gap between drain
hose and floor drain.
PN: 10130.00
181-VL REAR VIEW
STEP
2
Connect dishmachine to cold water source.
TUBE
3
STIFFENER
CHEMICAL
TUBING
RED
BLUE
STEP
3
RED
BLUE
Insert tube stiffener with chemical tubing into
corresponding chemical dispensers.
5-2019
Advertisement
Table of Contents
Related Manuals for ALI CMA DISHMACHINES 181-VL
Summary of Contents for ALI CMA DISHMACHINES 181-VL
- Page 1 181-VL Quick Setup Instructions WARNING: Electrical and plumbing connections need to be made by a qualified service technician and comply with all available Federal, State 181-VL REAR VIEW and Local Health, Electrical, Plumbing and Safety codes. TUBE STIFFENER CHEMICAL TUBING HARD WIRE FOUR WIRE POWER SUPPLY...
- Page 2 Dishmachine must be level front to back and side filled to correct level. No need to hold. Due to increase. slow fill rate this step may have to be repeated. to side. PN: 10130.00 5-2019 an Ali Group Company The Spirit of Excellence...
Need help?
Do you have a question about the CMA DISHMACHINES 181-VL and is the answer not in the manual?
Questions and answers