Epson PowerLite 7850p Product Information Manual page 16

12. Verify that you've enabled your computer's connection to
the access point. It should be listed as shown above, with
the small icon next to it, indicating a connection.
If it's not listed, click
Configure
your access point.
13. When done, click . Continue with "Projecting
OK
Wirelessly" on page 15.
Checking the Gateway IP Address
If you're entering IP addresses manually in Access Point mode
and need to find out the gateway IP address (the IP address of
your access point), make sure the wireless connection to the
access point is currently active, as described in the previous
section.
Note: If you can't identify the gateway address using this
Windows utility, use the administrator's utility software that
came with your access point.
1. Access your wireless network Properties window. For
example, in Windows XP click
Network and Internet Connections
double-click the
Network Connections
2. Right-click the
Wireless Network Connection
select . Then click the
Status
The gateway's (access point's) IP address is listed as shown:
Projecting Wirelessly
Once you've started EasyMP and set up your projector and
computer in either Ad Hoc mode or Access Point mode,
follow these steps to start NS Connection and project
wirelessly.
Note: You must have installed EMP NS Connection from your
projector CD-ROM. See the User's Guide for installation
instructions.
1. Make sure you've inserted the EPSON 802.11b card in the
projector's card slot (see page 11). Then select
from the Windows Start menu.
Connection
and then type the name of
Start > Control Panel >
. Then
icon.
icon and
tab.
Support
Gateway
address
EMP NS
EPSON PowerLite 7850p Projector
The first time you start NS Connection, you see a dialog
box asking you to select your network. Select the IP address
for your computer's network adapter card and click
Note: If you don't see your network adapter's IP address,
allow a minute for it to appear. If your access point uses
DHCP, sometimes it takes a minute for the server to pick up
the IP address.
You see the screen below. (If you have previously started
NS Connection, this is the first screen you see.)
Note: Once you've selected the IP address for your network
adapter, you won't see the Switch network dialog box when
you start NS Connection. If you want to change to a different
network adapter, click
Connection dialog box, then click
If the connection is working properly, you see your
projector listed. If you have additional projectors on the
network, they are also listed, along with their status. The
color of the status icon next to each projector's name
indicates its status:
❏ Gray: the projector is not connected
❏ Orange: the projector is connected to another
computer
❏ Green: the projector is connected to your computer
6/03 EPSON PowerLite 7850p Projector
on the EMP NS
Extension
.
Switch LAN
.
OK
15
-