Table of Contents
Advertisement
Quick Links
OFFICES - AUSTRALIA
OFFICES - OVERSEAS
NSW - Sydney
Waterco USA
(HEAD OFFICE)
Augusta, USA
Tel : +61 2 9898 8686
Tel : +1 706 793 7291
VIC/ TAS - Melbourne
Waterco Canada
Tel : +61 3 9764 1211
St-Hyacinthe, QC, Canada
Tel : +1 450 796 1421
WA - Perth
Tel : +61 8 9273 1900
Waterco (Europe) Limited
Radfield, Kent, UK
QLD - Brisbane
Tel : +44(0) 1795 521 733
Tel : +61 7 3299 9900
Waterco (NZ) Limited
SA/ NT - Adelaide
Auckland, New Zealand
Tel : +61 8 8244 6000
Tel : +64 9 525 7570
ACT Distributor
Tel : +61 2 6280 6476
Waterco Limited ABN 62 002 070 733
(W99245) 03/2009
Waterco (C) Limited
Guangzhou, China
Tel : +8620 3222 2180
Waterco (Far East) Sdn. Bhd.
Selangor, Malaysia
Tel : +60 3 6145 6000
PT Waterco Indonesia
Jakarta, Indonesia
Tel : +62 21 4585 1481
COMMERCIAL PUMP
Owners Manual
Installation and Operation
Cast Iron Pump
Hydrostar MK3
WARNING
This pool pump must be installed and serviced by a qualified pool/ spa technician
!
in accordance with all applicable codes and ordinances. Improper installation can
create electrical hazards which could result in death, serious injury, or property
damage. Improper installation will void the warranty.
Notice to Installer
This manual contains important information about the installation, operation and
safe use of this product. Once the product has been installed this manual must
be given to the owner/ operator of this equipment.
Hydrosteel Pump
www.waterco.com
Advertisement
Table of Contents
Related Manuals for Waterco HYDROSTAR MK3
Summary of Contents for Waterco HYDROSTAR MK3
- Page 1 Once the product has been installed this manual must Tel : +64 9 525 7570 ACT Distributor be given to the owner/ operator of this equipment. Tel : +61 2 6280 6476 www.waterco.com Waterco Limited ABN 62 002 070 733 (W99245) 03/2009...
-
Page 2: Table Of Contents
Electrical Installation Guide ----------------------- 08 All Waterco equipment is designed and manufactured to give many years of safe and reliable START-UP ----------------------------------------------------- 09 operation. We hope that you obtain the maximum pleasure and benefit from your new... - Page 3 Waterco Commercial Pump I pg 03 IMPORTANT SAFETY INSTRUCTIONS WARNING When installing and using electrical equipment, basic safety precautions should always be Equipment that is incorrectly pressure tested may fail, causing severe injury or property followed. This includes the following: damage.
-
Page 4: Installation
Waterco Commercial Pump I pg 05 INSTALLATION For models where the wet end is made out of a composite material instead of cast iron – DO NOT place any straps under the wet end for lifting – this will cause the wet end to crack. In Receive and Check Pump these scenarios –... -
Page 5: Piping Design And Installation
Three Phase Connections Three phase connections should be installed as follows: Both the suction and discharge lines should have a minimum pipe size as follows: a) Hydrostar Mk3: WYE/STAR CONNECTION for export market DELTA CONNECTION for Aus/NZ market a) Hydrostar Mk3... -
Page 6: Electrical Installation Guide
These pumps are designed to be used in pool recirculation systems with water at temperatures above 4°C (39.2°F) and not exceeding 40°C (104°F). Please refer to the Waterco Warranty b) Make sure that the wiring voltage matches the motor voltage. If they do not match the Terms and Conditions booklet supplied with the pump. -
Page 7: Maintenance
Waterco Commercial Pump I pg 11 MAINTENANCE Winterizing WARNING If the air temperature drops below 0°C (35°F), the water in the system can freeze and cause damage. Freezing damage is not warrantable. DO NOT open the strainer pot if the pump fails to prime or if the pump has been operating To prevent freezing damage follow the procedures listed below: without water in the strainer pot. -
Page 8: Electric Motor Care
AND PUMP BODY WARNING If the Waterco Limited pump is within the stated warranty period and you experience faults, always contact your supplier or the nearest Waterco Limited branch for advice. Failure to do this may void the warranty. Refer to warranty documentation supplied with the pump. -
Page 9: Hydrostar Mk3
Waterco Commercial Pump I pg 15 HYDROSTAR MK3 HYDROSTEEL Pump performance curves Pump performance curves Hydrosteel Pump Performance Chart Hydrostar Mk3 Performance Curves Flow (lpm) 1000 1200 1400 1600 1800 Flow (lpm) 1000 1200 1400 Flow (m /hr) 0 Flow (m... -
Page 10: Cast Iron Pump
5.5kW 1070 7.5kW 1070 11kW 1198 WARRANTY WARNING Waterco Commercial pumps are covered by a comprehensive 1 year warranty for commercial Flow (lpm) 1000 1500 2000 2500 installations. Please consult the Waterco Warranty Terms & Conditions booklet included Flow (m /hr) 0 with the pump for further information.